V-Cut虽然可以方便我们轻易的将板子分开并去掉板边，但V-Cut也是有设计及使用上的一些限制。
Although V-Cut can facilitate us to easily separate the boards and remove the edges, V-Cut also has some limitations in design and use.
，V-Cut只能切直线，而且一刀到底，也就是说V-Cut只能切割成一条线直直的从头切到尾，它无法转弯改变方向，也不能像裁缝线一样切一小段后跳掉一小段。这是因为V-Cut的凹槽是使用上下两片圆盘的电锯所切出来的，有看过木工师傅裁切木头吧，意思大概就是那样，因为PCB的裁切都要很精淮（毫米计算），所以无法做到只切一半就退刀的作业，其实也不是做不到，而是没有必要大费周章这么做，我们只要放弃V-Cut分板的制程，改用Routing去板机来裁切板子就可以达成了。所以一般如果是比较複杂的切断路径，就会改用Routing机来分板。
First, V-Cut can only cut a straight line, and a knife to the end, that is, V-Cut can only cut into a straight line from the head to the tail, it can not turn to change direction, and can not cut a small segment like a tailor line and jump a short section. This is because the grooves of the V-Cut are cut out by the saws that use two discs up and down, and have seen the woodworker cut the wood, which is probably the same, because the cutting of the PCB must be very fine (millimeter calculation), so it is impossible to cut the knife only half and not do it, but it is not necessary, but not necessary. If we do so, we just need to give up the process of V-Cut sub board and switch to the Routing board to cut the board. So in general, if it is a complex cut off path, it will be replaced by Routing.
其次，PCB在行经回焊炉的高温时，板子本身就会因为高温超过玻璃转移温度(Tg)而软化变形，如果V-Cut位置及凹槽深度设计得不好，会使得PCB变形更会严重，不利二次回焊制程。
Secondly, the PCB will soften the deformation because of the high temperature exceeding the glass transfer temperature (Tg). If the V-Cut position and the depth of the groove are not well designed, the PCB deformation will be more serious and the two return welding process is disadvantageous to.
另外，PCB厚度太薄也不适合做V-Cut凹槽，一般如果厚度在1.0mm以下的板子，深圳宏力捷就不建议做V-Cut了，这是因为V-Cut凹槽会破坏原本PCB的结构强度，当有设计V-Cut的板子上面放置有比较重的零件时，会因为重力的关系而使得板子变得容易弯曲，这非常不利SMT的焊接作业（容易造成空焊或短路）。
In addition, the thickness of PCB is too thin to be suitable for V-Cut grooves. Generally, if the thickness is below 1.0mm, Shenzhen macroczech will not recommend V-Cut. This is because the V-Cut groove will destroy the original structural strength of the original PCB. When there is a relatively heavy zero part on the board of the designed V-Cut, it will make the plate because of the relation of gravity. The child becomes easy to bend, which is very unfavorable to the welding operation of SMT (which is likely to cause air welding or short circuit).